Skip to content

Stacked Flare Jeans With a Hem That Keeps Its Break

Stacked flare jeans from 300 pcs: a 24–30 cm hem, 32–34 inch inseam and a knee-to-hem ratio tested after 3 washes, not on the greige.

Denim style from our production range

A stacked flare is a hem with too much cloth and no place to go. The extra length folds over the shoe in 2–4 horizontal breaks, which only works if the flare starts at the knee and the inseam is cut 2–4 inches longer than a straight leg.

We cut stacked flare in 10.5–12.5 oz denim with 1–2% elastane, hem opening 24–30 cm flat, inseam 32–34 inches. The knee-to-hem ratio is the number that decides whether it stacks or drags.

  • Hem opening 24–30 cm flat, 48–60 cm sweep
  • Inseam 32–34 inches, 2–4 inches over a straight leg
  • Knee 20–22 cm flat, flare drafted from the knee down
  • 10.5–12.5 oz with 1–2% elastane for drape
Send a hem reference
Denim style from our production range
Where the extra length goes

The flare is drafted from the knee down: 2–3 cm added per side at the hem, with the knee held at 20–22 cm. If the flare starts above the knee the leg reads as a bell-bottom; if it starts below, it reads as a boot cut with a wide hem.

Stacking is a function of length and hem weight. A 34-inch inseam on a 30-inch leg gives 4 inches of break, which folds into 2–3 stacks. A raw hem stacks softer than a 1.2 cm double-needle hem, because the folded hem adds weight and stops the cloth from collapsing.

  • Flare starts at the knee, 2–3 cm per side
  • Hem finish: raw, 1.2 cm double-needle, or chain stitch
  • Inseam 32–34 inches; state the break you want
  • Back rise 1 cm longer for the stacked seat
Knee-to-hem ratio and the 3-wash collapse

The knee-to-hem ratio is hem opening divided by knee opening. A straight leg runs 0.8–0.9; a stacked flare runs 1.1–1.3. Below 1.1 the stack looks like a wrinkled straight leg; above 1.3 the hem drags and the back of the jean scuffs.

Soft denim collapses. After 3 home washes a 10.5 oz stretch flare can lose 1–2 cm of hem width and the stack flattens. We test the ratio on the washed sample, not the greige, and we add 0.5 cm to the hem to allow for it.

  • Ratio 1.1–1.3, measured on the washed garment
  • Hem allowance of +0.5 cm for wash collapse
  • Inseam re-checked after 3 washes, 2–3% shrinkage
  • Back hem 1 cm longer than the front for the break
Denim style from our production range
Stacked flare parameters
  • Hem opening: 24–30 cm flat, 48–60 cm sweep
  • Knee opening: 20–22 cm flat
  • Knee-to-hem ratio: 1.1–1.3 on the washed garment
  • Inseam: 32–34 inches, 2–4 inches over straight
  • Fabric: 10.5–12.5 oz with 1–2% elastane
  • Rise: Mid 26–28 cm, high 30 cm at size 32
  • Hem finish: Raw, 1.2 cm double-needle, chain stitch
  • Shrinkage: 2–3% warp, hem allowance +0.5 cm
  • Wash options: Rinse, stone, enzyme, tint, overdye
  • Sizes: 24–36 women, 28–40 men
  • MOQ: 300 pcs per style per color
  • Bulk: 25–35 days after PP approval

Stacked flare is a sizing decision first

The same pattern sells as a stacked flare or as a dragging hem depending on the inseam you order. A 32-inch inseam on a 34-inch leg is a clean flare; a 34-inch inseam on the same leg is a stack. Buyers who specify a flare without a break instruction get whatever the standard block does, and the returns tell them which one they got.

The trade-off is fabric and risk. Extra length adds 8–12% fabric consumption, and every extra inch of inseam is another inch that can shrink, twist or hem unevenly. A raw hem saves the hem operation and stacks better, but it frays and is not accepted as a finished hem in some markets. Choose the hem finish by market, then set the inseam.

  • US streetwear: 34-inch inseam, raw hem, 26–30 cm opening.
  • EU retail: 32-inch inseam, double-needle hem, 24–26 cm.
  • First order: one inseam, two washes, 300 pcs per color.
Frequently asked questions
What is a stacked flare jean?

A flare cut with 2–4 inches of extra inseam so the hem folds over the shoe in 2–4 horizontal breaks. The flare starts at the knee, the hem opens to 24–30 cm flat, and the extra length is what creates the stack rather than a wider leg alone.

What inseam should I order for stacked flare jeans?

32–34 inches for most markets, which is 2–4 inches longer than the same fit in a straight leg. A 34-inch inseam on a 30-inch leg produces 4 inches of break and 2–3 stacks. State the break you want, or the block will default to ours.

What hem opening makes a flare rather than a boot cut?

24–30 cm flat at the hem, against 17–18 cm for a straight leg. What separates a flare from a boot cut is where the widening starts: at the knee for a flare, below it for a boot cut. A knee-to-hem ratio of 1.1–1.3 keeps the line clean.

Will the stack disappear after washing?

It can flatten by 1–2 cm on a 10.5 oz stretch denim after 3 washes, because the fabric relaxes and the hem draws in. We test the ratio on the washed sample and add 0.5 cm to the hem so the stack survives the first month of wear.

What fabric works for stacked flare jeans?

10.5–12.5 oz with 1–2% elastane. Rigid 12 oz holds a sharper stack but folds in fewer, harder breaks and can look like a wrinkled straight leg. Softer stretch denim drapes into more breaks and photographs better, at the cost of some hem width after washing.

Tell us what you want to make

Share the style, target quantity and launch date. You get fabric options, wash recommendations, a sampling date and a factory-direct quote — usually within 12 working hours.

Need a quick answer?

Message our merchandising team on WhatsApp — we reply within 12 working hours.

WhatsApp +86 138 0000 0000